arcelik BEKO COSMOS, Руководство по обслуживанию, Страница: 29 / 274

SBS COSMOS REFRIGERATOR
07.11.2018 / REV NO: 01
29
Sensitivity: Public
8.3. Before you start using the ice/water dispenser
A separate pump should be used if the water pressure drops below 1 bar or a jug is being
used.
Water system of the refrigerator should be connected to the cold water line. It
should not be connected to hot water line.
No water may be obtained in the initial operation of the refrigerator. This is due
to the air contained in the system. To discharge air from the system, press
dispenser latch for a period of 1 to 2 minutes until water comes from the
Dispenser. Water flow may be irregular at the beginning. Water flow will be
normalized after the air in the system is discharged.
12 hours should pass from the first installation of the refrigerator before cold
water can be obtained.
1-2 days should be waited in order to complete the ice-making process to the
desired amount.
Water mains pressure must be between 1-8 bars for the smooth operation of
ice/water dispenser. You can verify by checking whether 1 glass of water (100
cc) can be filled in 10 seconds.
The first 10 glasses of water should not be consumed.
Approximately 12 hours must pass to obtain ice or cold water from the ice/water
dispenser for the first time. If there is not enough ice in the ice dispenser, ice
may not be obtained from ice dispenser.
The first 30 ice cubes should not be consumed.
Always use the water filter when a jug is not being used.
When the filter is used for the first time, first few glasses of water may come
blurred. Therefore, first few glasses of water should not be consumed.
First 1-2 glasses of water may be warm when ice/water dispenser was not used
for a long time.
If a power cut or a temporary failure occurs during the operation of the
refrigerator, some ice may melt and freeze again. In this case, ice pieces may
stick to each other. If the power cut or failure lasts for a long time, ice may melt
and cause water leakage. If you experience such a problem, empty the ice in the
ice container and clean the ice container.
If you will use the Ice Off function, empty the ice retained in the ice container. If
ice is kept in the ice container, ice pieces may stick to each other.
Water system installation of the refrigerator must be performed by authorized
service.