10 / 29 EN
Refrigerator / User Guide
4
Installation
4.1 The right place for installation
Your product requires adequate air circulation to
function efficiently. If the product will be placed
in an alcove, remember to leave at least 5 cm
clearance between the product and the ceiling,
rear wall and the side walls.
If the product will be placed in an alcove,
remember to leave at least 5 cm clearance
between the product and the ceiling, rear wall and
the side walls. Check if the rear wall clearance
protection component is present at its location (if
provided with the product). If the component is
not available, or if it is lost or fallen, position the
product so that at least 5 cm clearance shall be
left between the rear surface of the product and
the wall of the room. The clearance at the rear is
important for efficient operation of the product.
4.2 For Products With Water
Fountain / Ice Maker
• The hose sets supplied with the product shall be
used. Do not use the old hose sets. Do not extend
the hoses!
• Always connect your product to cold water inlet.
Do not perform installation on the hot water inlet.
The pressure for the cold water inlet shall be 80 PSi
(550 kPa) maximum. If your water pressure exceeds
80Psi or has a water impact effect, use a pressure
limiting valve on your mains system. Ask help from
professional plumbers if you do not know how to
control your water pressure.
High pressure may cause damage to the hose
connections and pose a risk of flooding.
• Take required precautions against the risk of
freezing of hoses. The operating water temperature
interval shall be 0.6°C (33°F) minimum and 38°C
(100°F) maximum. There is a risk of flooding if the
hose is cracked/perforated.
A
WARNING:
Do not use extension or multi
sockets in power connection.
B
WARNING:
The manufacturer assumes
no responsibility for any damage caused
by the work carried out by unauthorized
persons.
B
WARNING:
The product's power cable
must be unplugged during installation.
Failure to do so may result in death or
serious injuries!
A
WARNING:
: If the door span is too
narrow for the product to pass, remove
the door and turn the product sideways; if
this does not work, contact the authorized
service.
• Place the product on a flat surface to avoid
vibration.
• Place the product at least 30 cm away from the
heater, stove and similar sources of heat and at
least 5 cm away from electric ovens.
• Do not expose the product to direct sunlight or
keep in damp environments.
• The product requires adequate air circulation to
function efficiently. If the product will be placed
in an alcove, remember to leave at least 5 cm
distance between the product and the ceiling
and the walls.
4.3 Attaching the plastic wedges
Use the plastic wedges in the provided with
the product to provide sufficient space for air
circulation between the product and the wall.
1.
To attach the wedges, remove the screws on
the product and use the screws provided with the
wedges.
2.
Attach 2 plastic wedges on the ventilation cover as
shown in the figure.
Read the “Safety Instructions” section first!