Service Support Spirit
56
Unique Solution
WWW.ARCBRO.COM
Conversion angle of corner speed
----- When the running direction changes between program segments
and changing angle exceeds this angle, the system will decelerate to the starting speed around the corner.
This value is normally set smaller when the system is comparatively heavier. In addition, such considerations
as machining speed and machine vibration should be taken as well, smaller value for worse vibration.
Circular corner transitional option -----
If this option is enabled(value:1), the system will not decelerate
through a circular transition when the running direction change of system between program segments is
within the conversion angle of corner speed, as shown in the figure below.
A<
拐角速度转换角
R
拐角圆弧过渡半径
运行方向
8
）
Circular corner transitional radius ----
Refer to circular corner transitional option.
12.2.2. System parameters
In the SETUP submenu, press [F2] key to enter system parameters setting window, as shown in Fig.12.3.
Fig. 12.2 Speed parameters setting
SETUP main
Parameters
display zone
ESC
Parameter
setting range
