5692 FRESCA DRIVE, LA PALMA, CA 90623 | 800.585.5957 | ARCADIACONTRACT.COM
CO-OP ASSEMBLY INSTRUCTIONS – MODELS 6553
Hardware Included:
[A] Wall guide (1)
[B] Wall attachment pin bracket (2)
[C] ¼-20 x .75” flat head decorative screws (8)
[D] Floor mount bracket (1)
[E] 3/8 x 5” anchor bolt (1)
IMPORTANT – HARDWARE IS SPECIFIC FOR THE ASSEMBLY OF EACH COMPONENT. MAKE SURE THE
CORRECT ITEMS ARE USED AS DIRECTED AND IDENTIFIED BELOW.
Step 1: Position the wall guide [A] 77.97” from the floor to the center of the guide. Ensure it is level to the
floor and drill the four holes through the wall using the four holes on the guide. Secure the floor mount
bracket [D] by first placing it 58.15” from the wall to the center of the bracket and use (1) 3/8 x 5”
anchor bolt [E] (Figure A). Two people are recommended for this part of the assembly.
Step 2: Once the holes have been drilled into the wall, remove the wall guide and place the wall attachment
pin brackets [B] over the holes that were just made and properly secure to the wall (Figure B).
continued next page
[A]
[B]
[C]
[D]
[E]
FIGURE A
FIGURE G
[B] Wall attachment pin bracket, 1
[D] Floor mount bracket, 1
