ARBOS MEK-X250, Руководство по эксплуатации и обслуживанию

Страница: 21 / 42

Use and Maintenance Manual
Page 21
6.8. LOW LEVEL SENSOR
The seeder is equipped with a device which controls the seed
level inside the hopper.
Fig. 12
LOW LEVEL
Fig. 13
6.9. DETACHING FROM THE MACHINE
When you park the machine, it is necessary to:
• Apply the tractor parking brake;
• Place the machine on flat ground, making sure that it is
stable;
• Stop the tractor engine;
• Extract the ignition key from the control panel and keep
it safe;
• Come down from the driving position;
• Carefully unload all the seeds;
• Remove the pin and pivot and detach the tie-rod (third
point);
• Remove the anti-thread pins and connection pivots and
then the back hydraulic lifting arms of the tractor from
the connection points on the machine;
• get back into the tractor cab;
• start the tractor and move away carefully
• Protect the equipment with a sheet.
The land on which the machine is
parked must be flat and within a
protected area so that only those
authorized may approach it.
7. ADJUSTMENTS
To obtain correct seed density per hectare (Kg/Ha), the distri-
bution organs must be properly adjusted (gearbox, feelers,
graduated slide gates).
7.1. FEELER ADJUSTMENT
The adjustment lever of the feelers acts on a graduated scale
from 1 to 7.
On the basis of the type of seed used for sowing, position the
feelers according to the indications provided in the adjust-
ment table.
Correctly positioned feelers ensure fluid and constant seed
distribution.
To obtain the best seed distribution, check the position of the
feelers regularly, setting the lever to position 1 and checking
that they are all in the same position in relation to the sep-
arator inside the distributor. If this is not the case, correct the
error by acting on the screw
18
behind the distributor.
Fig. 14
18
Fig. 15
Do not adjust the feelers with the distributors full of seed.
If necessary, close the slide gates, empty the dispensers,
adjust the feelers and reset the slide gates as before.