arboga POP 310, Руководство пользователя

Страница: 10 / 24

10
3 Belt arm
3.1 Assembling and mounting the belt arm
Mount the telescope arm (A) to the box cover (B) by using the fittings for the
telescope arm (C) and securing the box cover (B) by screwing the screw through the
side plate into the holder for the telescope arm (D). The top roller (E) must be inside
the box cover (B).
Fig.: 3.1
Do not tighten the fittings for the telescope arm (C) any harder than it is still possible
to adjust the running direction of the grinding belt.
The belt arm can be tilted to the desired inclination and then the holder for the
telescope arm (D) is secured by tightening the two screws placed in the ring of the
holder.
Flanges, contact wheel and reverse nut is mounted (see split drawing for right order).
Check that the top roll (E) and the contact wheel are aligned. The position of the
contact wheel can be adjusted by means of the distance rings enclosed. The top roll
(E) can be loosened and adjusted to the point where it fits the desired grinding belt
length. In the same way the grinding belt can be tightened.