Arbiter Systems 1201B, Инструкции по эксплуатации

Страница: 123 / 228

11.2 Standard Command Set 105
Return Longitude
Command: LO
LO returns the current antenna longitude.
Response: Wddd:mm:ss.sss
C
Format: W = West (E for East), ddd = degrees, mm = minutes, ss.sss = seconds
11.2.9 Date and Time Commands
Set Receiver Time
Command: yyyy:mm:dd:hh:mmTS
TS sets the receiver to UTC time only when not locked to the GNSS . The command is ignored when locked
to satellites. When the receiver is initially activated, and has not locked onto satellites, acquisition time may
be improved by giving the clock an initial estimate of UTC time, which it can use (with stored position and
almanac data) to determine which satellites and Doppler shifts to use in acquisition.
Response:
C
Format: yyyy = year, mm = month, dd = day, hh = hour, mm = minute
Return Local Date, Return UTC Date
Command: DL, DU
DL returns the current date, in the Local time zone. DU returns the current date, in the UTC time zone.
Response: ddmmmyyyy
C
Return Local Time, Return UTC Time
Command: TL, TU
TL returns the current Local time. TU returns current UTC time.
Response: ddd:hh:mm:ss
C
NOTE: The DL, DU, TL and TU command formats are identified as follows: yyyy = year, hh = hour,
mmm = month (JAN to DEC), mm = minute, dd = day of month, ss = second, ddd = day of year(1 - 366).
11.2.10 Programmable Pulse Output Commands
Pulse Width, Seconds-Per-Pulse
Command: nnn.nnPW
nnn.nnPW configures the Programmable Pulse output pulse width in seconds (rear panel connector).
Response:
C
Format: nnn.nn (0.01 to 600 seconds in 10-millisecond increments).
For values greater than 1, use a decimal point and enter trailing zeros as applicable.
Examples:
1 = 0.01 second
10 = 0.10 second
1.00 = 1 second
100 = 1 second