01/03/06
Page 1 of 1
3782640 rev2
If you have any queries regarding the installation of this product please contact the distributor from whom it was purchased, or alternatively the ARB office in your state.
Head Office – ARB corporation Ltd VIC:
42-44 Garden Street, Kilsyth, Victoria, 3137 Tel: (03) 9761 6622 Fax: (03) 9761 6807
WA:
(08) 9244 3553
NSW:
(02) 9821 3633
ACT:
(02) 6280 7475
SA:
(08) 8244 5001
QLD:
(07) 3872 3872
NT:
(08) 8947 2262
TAS:
(03) 6331 4190
DELUXE /WINCH BULL BAR TO SUIT
LAND ROVER DEFENDER & 110
PART No: 3432090, 3432160 (MODELS WITH FORWARD PROTRUDING GRILL)
WARNING
THIS BULL BAR MUST NOT BE FITTED TO AIRBAG EQUIPPED VEHICLES.
FITMENT TO AIRBAG EQUIPPED VEHICLES MAY INTERFERE WITH THE
PROPER OPERATION OF THE AIRBAGS AND MAY RESULT IN SERIOUS INJURY.
TAKE NOTE OF THE FOLLOWING:
•
THIS PRODUCT MUST BE INSTALLED EXACTLY AS PER THESE INSTRUCTIONS USING ONLY THE
HARDWARE SUPPLIED.
•
IN THE EVENT OF DAMAGE TO ANY BULL BAR COMPONENT, CONTACT YOUR NEAREST AUTHORISED
ARB STOCKIST. REPAIRS OR MODIFICATIONS TO THE IMPACT ABSORPTION SYSTEM MUST NOT BE
ATTEMPED.
•
DO NOT USE THIS PRODUCT FOR ANY VEHICLE MAKE OR MODEL, OTHER THAN THOSE SPECIFIED BY
ARB.
•
DO NOT REMOVE LABELS FROM THIS BULL BAR.
•
THIS PRODUCT OR IT’S FIXING MUST NOT BE MODIFIED IN ANY WAY.
•
THE INSTILLATION OF THIS PRODUCT MAY REQUIRE THE USE OF SPECIALISED TOOLS AND / OR
TECHNIQUES.
•
IT IS RECOMMENDED THAT THIS PRODUCT IS ONLY INSTALLED BY TRAINED PERSONNEL
•
THESE INSTRUCTIONS ARE CORRECT AS AT THE PUBLICATION DATE. ARB CORPORATION LTD.
CANNOT BE HELD RESPONSIBLE FOR THE IMPACT OF ANY CHANGES SUBSEQUENTLY MADE BY THE
VEHICLE MANUFACTURER.
•
DURING THE INSTILLATION, IT IS THE DUTY OF THE INSTALLER TO CHECK CORRECT OPERATION/
CLEARANCES OF ALL COMPONENTS.
TOOLS REQUIRED -
Basic tool kit
PROCEDURE -
WINCH & ROLLER FAIRLEAD FITMENT
New mounting holes must be drilled in the roller fairlead to line up with the winch mounting holes in the
bull bar.
1. Remove circlips from the pins retaining the side rollers.
2. Remove side pins and side rollers from roller fairlead.
3. Position roller fairlead hard up against roller fairlead bracket on the bull bar.
