AR 10052412, Руководство по эксплуатации и обслуживанию

Страница: 54 / 80

Model 5000A225C
30 Rev A
2.8.6.8 ALC Detector Gain Adjust
This command sets the ALC detector gain, in percent. Use this setting to change how aggressively the ALC
feature reacts when the ALC Threshold value has been exceeded.
Syntax:
LEVEL:DET<det gain>
<det gain>: Specifies the ALC Detector Gain in % from 0 (least aggressive) to 100 (most
aggressive).
Query:
No (see the Machine State query command)
Example
To set the RF Detector Gain to maximum aggression, send the following
command:
LEVEL:DET100<LF>
Default Value:
50%
2.8.6.9 ALC Threshold Level Adjust
This command allows the user to adjust the internal ALC threshold value between 0% (no gain) and 100%
(default ALC Threshold Level). The default ALC Threshold level cannot be exceeded.
For instance, setting the threshold to 50% will limit the RF Output to 50% of the default threshold level.
Syntax:
LEVEL:THR<thresh val>
<thresh val>:
Specifies the ALC Threshold value in % from 0 (no gain) to 100 (default ALC
Threshold value)
Query:
No (see the Machine State query command)
Example To set the ALC Threshold Level to half of the default value, send the following
command:
LEVEL:THR50<LF>
Default Value:
100%
2.8.6.10 ALC Response Setting Adjust
This command sets the ALC response setting. Adjusting this setting changes the ALC’s response time when
reacting to a detected increase in the RF Output that exceeds the ALC Threshold Level.
Syntax: LEVEL:RESP<resp setting>
<resp setting>:
1 (fastest) to 7 (slowest), see table below
Query: No (see the Machine State query command)
Example: To set the ALC response time to its slowest value, send the following
command:
LEVEL:RESP7<LF>
Default Value:
1
Note: Response Settings Time (S)
1 5m
2 10m
3 30m
4 100m
5 1
6 3
7 3