9BL
Aquverse Water Cooler Troubleshooting Instructions Supplement
*
*Warning do not plug water cooler in until water bottle is in place and dispensing water through the faucets**
Parts Extraction:
1.
To Remove Faucet
Covers and Faucets
A.
Grip faucet cover in hand and turn left or right to unlock. Pull down once unlocked.
See figure A
and B
below.
B. Remove front panel cover ( 3 screws hold the panel in place. 2 screws internally and 1 screw near faucets)
C.
Grip faucet in hand and unscrew faucet counter clockwise
. See figure
C
below.
b. Grip baffle from two opposite sides a
pwards out of the c
dy (see figure I below)
Figure I
3. To Remove Faucets
a. Grip faucet in hand and unscrew faucet counter clockwise (see figure J below)
Figure J
General Information Helpful To Trouble Shooting
1. Note that your cooler is built with a no spill kit (see figure K below). This unit is designed to be used with a bottle
that has a cap made to be punctured by our probe (see figure L below). The bottle cap (see figure M below) can be
taken off if you also remove the no spill kit completely (see figure N below)
Figure K
Figure L
Figure M
Figure N
2. To Remove Baffle From Top of the Water Cooler
a. Turn the Baffle counter clockwise till the open arrow meets the corresponding arrow on the top of the cooler
body (see figure G and H below)
General Information Helpful To Trouble Shooting
1. This unit is designed to be used with a bottle
that has a cap or a bottle without a cap. The bottle probe
will puncture and seal a cap bottle with a cap or simply slide on to a bottle without a cap. Please see
figure
below.
2.
If cooler is not functioning make sure you are using a working outlet by testing it with a lamp
What To Do If:
1.
Cooler Is Not Dispensing Water
A.
Make sure water bottle is full
B.
Make sure the water bottle is being properly pierced by the
bottle probe kit
C.
Make sure you have removed the bottle probe kit cover (little black cap
on the end
)
D.
Confirm that cooler is not frozen by:
-Removing the 9BL lid, removing the 9BL float, and checking the cold water tank
(see figures
F
below
)
E.
Check water bottle to determine if cap is jammed and not dispensing water (see figure
G
below)
Figure P
Figure Q
2.
Cooler Is Not Dispensing Chilled Water
a. Check that cold water thermostat is not turned to the off position (see figure R below)
Figure R
b. Determine whether the compressor is working by putting your ear close to the top of the cooler with the
bottle off (if you hear silence, the compressor is not working, if you hear a humming noise the compressor is
working)
Figure
G
F.
Check faucets to determine if water is able to flow through when in on position (see figure
H
and
I
below)
2.
To Remove Lid
A.
Turn the cooler around so you are facing the back (wire caged portion).
B.
Locate the 2 screws holding the lid in place (on the left and right side of the lid) See figure
D
below.
C.
Locate the tab securing the lid in place and gently push towards the front. See figure
E
below.
3.
To Remove UV Float
A.
Follow the steps in how to remove the lid from above.
B.
Once lid is removed you will be looking at the cold tank
and float system.
C.
Locate
the UV float lip and pull up until UV float separates from the cold tank.
D. See images below.
Figure
B
Figure C
Figure D
Figure A
Figure E
Figure F
Figure H
Figure I
