TEMPERATURE AND PRESSURE LIMITS
Minimum Pressure 35kPa
Maximum Pressure 1000kPa
Maximum hot water Temperature 70 degrees Celsius
For cold water pressure above 600kPa we recommend the installation of a pressure
limiting valve.
We recommend using a line strainer on both hot and cold supply lines to this mixer. This
will help protect the ceramics in your mixer.
CLEANING
To retain the original look of your Aquatica laundry product, please follow these simple
suggestions:
DO NOT use acidic, abrasive, chlorine or alcohol based cleaners. Many of these products
can damage chrome and powder coated surfaces.
DO remove dirt or calcium stains with soap and water, rinse with clean water and dry
with a clean soft cloth.
Aquatica NZ Ltd offer, from the date of purchase, a 5 year guarantee on the
cabinet and taps and a 25 year guarantee on the laundry bowl. Aquatica NZ Ltd
warrants that only high quality workmanship and materials have been used in
the manufacture of the laundry tubs. The guarantee is transferable but original
proof of purchase is required. If any faulty workmanship or materials are
proven during the warranty period Aquatica NZ Ltd will, at its own cost, repair
or, at its option, replace the faulty product. If spray or abrasive cleaners are
used on the chrome and powder coated surfaces, it will void the warranty. (The
chrome and cabinet should only be cleaned with mild detergent on a soft damp
cloth).
Failure to use an in-line strainer or filter on the mixer may also void the
warranty. Pressure limiting is recommended above 600kPa and should never
exceed 1000kPa.
INSTALLATION INSTRUCTIONS
AQ LAUNDRACENTRO
AQ LAUNDRATUBBIE
AQ LAUNDRATUBBIEPLUS
AQ LAUNDRASLIM
AQ LAUNDRASLIMPLUS
AQ LAUNDRAMAX2
AQ LAUNDRAMAXSLIM2
DRAWER MODEL
If you have a drawer model, read below. If not, ignore this section.
Drawer Removal
Drawer models require the removal of the drawers to complete the supply
and waste connections. The top drawer is removed by opening fully and
then lifting the drawer front upwards until the drawer
runners disengage.
To remove the bottom drawer, almost fully extend the
drawer and remove the clear rubber blocks from the
drawer runners (pictured). Then disengage the grey
lock tabs by sliding backwards, then forwards (pictured).
Now fully extend the drawers and lift the drawer front
upwards until the runners disengage.
DOOR MODEL
If you have a door model and want the door to swing from the other side, read below.
If not, ignore this section.
Door Reversal
Open door and remove locking nut from top pivot pin and then unscrew pivot pin.
Lift door off bottom pivot pin
Remove the magnets and refit to opposite side of door frame (4 screws).
Remove bottom pivot pin and nylon washers. Relocate pin and washers
to opposite side of the door frame.
Rotate door 180 degrees
Relocate door basket by removing 4 x screws and repositioning
brackets to the new bottom of door.
Fit door to bottom pivot pin. Ensure the nylon washers are between
the door and the frame.
Refit top pivot pin and locking nut.
Refit door basket to locating tabs on door brackets.
PLUS MODEL (ie. Pull-Out Spray Mixer)
If you have a Plus model, read below. If not, ignore this section.
To prevent damage to the tap and cabinet, the pull-out spray tap is not fitted to the
cabinet during transport.
The mixer should be installed before installation of the cabinet. When installing
pipes and fittings, ensure they do not interfere with the pull-out spray.
