T5HO Hybrid Fixtures (White with Decor Endcaps)
Models: 420558, 420559, 420560, 420561
Installation, Operation & Maintenance Guide
www.aquaticlife.com
1
Thank you for purchasing an Aquatic Life
T5HO Hybrid Fixture.
When maintained properly, this unit will
provide you with years of service.
WARNING:
Please read carefully before proceeding with
installation. Your failure to follow any attached instructions and
operating parameters may lead to the product’s failure.
A) READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
B) DANGER – To avoid possible electric shock, special care should be taken
since water is employed in the use of aquarium equipment. For each of the
following situations, do not attempt repairs by yourself; return the appliance to
an authorized service facility for service or discard the appliance:
1) If the appliance falls into the water, DON’T reach for it!
First unplug it and then retrieve it. If electrical components of the
appliance get wet, unplug the appliance immediately.
(Non-immersible equipment only)
2) If the appliance shows any sign of abnormal water leakage,
immediately unplug it from the power source. (Immersible
equipment only)
3) Carefully examine the appliance after installation. It should not be
plugged in if there is water on parts not intended to be wet.
4) Do not operate any appliance if it has a damaged cord or plug, or if it
is malfunctioning or has been dropped or damaged in any manner.
5) To avoid the possibility of the appliance plug or receptacle getting wet,
position aquarium stand and tank to one side of a wall-mounted
receptacle to prevent water from dripping onto the receptacle
or plug. A “drip loop,” shown in the figure to the
left, should be arranged by the user for each cord
connecting an aquarium appliance to a receptacle.
The “drip loop” is that part of the cord below the
level of the receptacle, or the connector if an
extension cord is used, to prevent water traveling
along the cord and coming in contact with the
receptacle. If the plug or receptacle does get wet,
DON’T unplug the cord. Disconnect the fuse or
circuit breaker that supplies power to the
appliance. Then, unplug and examine for presence
of water in the receptacle.
C) Close supervision is necessary when any appliance is used by
or near children.
D) To avoid injury, do not contact moving parts or hot parts such as heaters,
reflectors, lamp bulbs, and the like.
E) Always unplug an appliance from an outlet when not in use, before putting
on or taking off parts, and before cleaning. Never yank the cord to pull the
plug from outlet. Grasp the plug and pull to disconnect.
F) Do not use an appliance for other than intended use. The use of
attachments not recommended or sold by the appliance manufacturer
may cause an unsafe condition.
G) Do not install or store the appliance where it will be exposed to the
weather or to temperatures below freezing.
H) Make sure an appliance mounted on a tank is securely installed
before operating it.
I) Read and observe all the important notices on the appliance.
J) If an extension cord is necessary, a cord with a proper rating should
be used. A cord rated for less amperes or watts than the appliance rating
may overheat. Care should be taken to arrange the cord so that it will not
be tripped over or pulled.
K) For added safety, the appliance must be plugged into a receptacle
controlled by a GFCI (ground fault interrupter) circuit breaker. The device
must be properly connected to a grounded three-prong receptacle.
L) This appliance is intended FOR HOUSEHOLD USE ONLY.
M) This Light Fixture is required to be used over a covered aquarium.
A glass top or protective barrier is required to minimize the fixture’s
exposure to water.
N) SAVE THESE INSTRUCTIONS.
Drip
Loop
Contents
420558
24"
420559
36"
420560
48"
420561
61"
Two Lamp Fixture Housing
2
2
2
2
Metal Endplate
2
2
2
2
Endplate Screws
10
10
10
10
18" Decor Endcaps
2
2
2
2
Rectangular LED Bracket
2
4
6
8
Decor Endcap Screws
8
8
8
8
Bracket Screws
6
10
14
18
Suspension Hardware
2
2
2
2
Tools Recommended for Installation
Phillips Screwdriver
