Instruction Sheet
Instructions for Setup of the AMK-WB
The transmitter and receiver are programmed as matched at the factory. No more
programming is required, Additional transmitters will require programming with the
receiver.
88C Jefferson Blvd, Warwick, RI 02888 ● 401-785-3000 ●Fax: 401-785-3033 ● [email protected]
Effective: 9/5/14
Supersedes: New
IS-AM09-606
1.
T
he transmitter and receiver must be within 100
feet of each other in an open area when using
or programming. They work best when avoiding
metal surfaces.
2.
On the wireless transmitter (remote control),
remove the yellow plastic band on the back of
the battery cover. The lamp on the front (above
the pushbutton) should light Red. Then press
the pushbutton, and the lamp should flash red.
3.
On the wireless receiver, plug the white antenna
into the side of the unit.
4.
On the wireless receiver, plug the pump into the
AC plug on the unit.
5.
Plug the power cord of the wireless receiver into
an AC outlet in the wall. The lamp on the
receiver will light red for a second.
6.
It is now ready to use. When the transmitter is
not being used, it should be docked in the
holder.
7.
To check this, press the pushbutton on the
wireless transmitter again to check that the
pump runs for 5 minutes. If it does not, then
follow the instructions for Programming of the
AMK-WB.
Instructions for Programming of the
AMK-WB
1.
The transmitter and receiver must be within
100 feet of each other in an open area
when using or programming. They work
best when avoiding metal surfaces.
2.
On the wireless transmitter (remote
control), remove the yellow plastic band on
the back of the battery cover. The lamp on
the front (above the pushbutton) should
light Red. Then press the pushbutton, and
the lamp should flash red.
3.
On the wireless receiver, plug the white
antenna into the side of the unit.
4.
On the wireless receiver, plug the pump
into the AC plug on the unit.
5.
Plug the power cord of the wireless receiver
into an AC outlet in the wall. The lamp on
the receiver will light red for a second.
6.
You must complete step 6 and 7 within 25
seconds or you will have to repeat them.
.
On the wireless receiver, press the white
SET button for about 10 seconds until the
lamp is constantly red.
7.
On the back of the wireless transmitter, use
a pen or nail to press the small red button.
This will make the lamp on the front to light
red for about 15 seconds. During this time,
press the pushbutton on the front. This
should turn off the red light on the wireless
receiver.
8.
Unplug the wireless receiver. Then plug it
back into the wall AC outlet. The lamp will
light red for 1 second.
9.
Please read the AMK-WB Time Window
explanation below to decide how long you
want your water to be hot before the next
step.
10.
Press the pushbutton on the wireless
transmitter. This should turn on the pump.
If it does not, then go back to step 6.
11.
For 5 to 10 minutes of hot water: on the
wireless receiver, press the white SET
button for about 6 seconds until the lamp
on the wireless receiver flashes twice in a
