AquaLabo Secomam STAC2, Руководство пользователя

Страница: 29 / 74

STAC2
- 29 -
6.1.1.2 Connection on a wired network
In the case of a connection on a network, there is generally a running DHCP service distributing IP
address to any devices connected on the network. Consequently, the STAC2 Ethernet port is
automatically configured with an IP address.
In the case of connection on a network without DHCP service, STAC2 must be configured with the same
IP address class than the default network
IP address : 192.168.200.xxx where “xxx” represent a value
from 1 to 255 . This last value must be selected as a free address value on the network to avoid any IP
address conflict on the network between STAC2 and another system.
6.1.2 WIFI SETTINGS
WIFI connection allow user to connect the STAC2 in a network without wire requirement (except if
MODBUS TCP/IP function is needed, in this case a Wire connection is required : see MODBUS chapter).
The STAC2 is able to connect itself automatically to two identified WIFI only. A user defined WIFI and a
rescue one.
A WIFI identification is made of two parameters: “SSID” & “Password”. The STAC2 try to connect every
minutes to a known WIFI network and connect itself to the best WIFI quality and power reception.
As a result, STAC2 will be connected by WIFI connection if one of the known WIFI network in detected.
direct wire connection
IP : 192.168.200.201
MASK : 255.255.255.0
GATEWAY : 192.168.200.200 (STAC2 IP)
IP : 192.168.200.200
IP : AAA.BBB.CCC.DDD
(IP is given by a DHCP service or fixed to a
defined value)
IP : AAA.BBB.CCC.DDD
(IP is given by a DHCP
service or fixed to a defined
value)