AquaCraft Bristol Trawler, Инструкция по эксплуатации

Страница: 7 / 8

7 7 77
Install the battery into the boat as shown in the picture.
At this time you can also install two AA batteries into the
battery holder that powers the lighting system. The switch
is located forward of the main power battery pack that turns
the light on and off.
With the transmitter on, plug a charged battery into the ESC.
You will hear the motor beep three times letting you know the
motor and ESC have power. Moving the left stick forward should
result in counter clockwise rotation of the propeller. Moving the
stick back should result in the propeller turning clockwise. If
this not correct, unplug the battery and switch revising switch
3 and test again. (Normal switch position is down.)
NOTE: The throttle trim lever allows more or less reverse
power without changing the full forward operation. To do this
simply plug in the battery with the throttle trim lever in the lowest
position. During power up the system will program to this trim
setting. This will provide the least amount of reverse power.
Moving the trim lever to the top and plugging the battery in will
provide the most amount of reverse power. You can position the
trim lever within the extents of the movement to custom adjust
the amount of reverse you want by simply adjusting the throttle
trim lever up or down and plugging in the battery.
Launching and Driving the Bristol Trawler
1. Turn the power on to the transmitter and receiver (in that
order).
2. Place the boat in water that is at least 12” deep and free of
weeds, sticks and obstacles.
3. Advance the throttle to half speed and note if the boat has
a tendency to turn right or left. Adjust the steering trim on
the transmitter until the boat runs straight when the steering
is at neutral.
4. After you have completed a run, unplug the boat’s power
battery. This safely powers down the boat. Then, turn off your
transmitter.
IMPORTANT: If your boat takes on a large amount of water
and stalls in the middle of the lake, don’t worry, your boat has
foam floatation so it will not sink . You will, however, have
to retrieve the boat and remove the cabin hatch and battery.
Remove any water that might have entered and allow the boat
to fully dry before operating it again.
Maintenance
It is important to remove and re-lubricate the drive system after
a day of running. Make sure the battery pack is unplugged.
Use a needle oiler to place one drop of oil on each end of the
motor shaft as well as each end of the drive shaft.
Ordering Replacement Parts
To order replacement parts for the AquaCraft Bristol Trawler, use
the order numbers in the replacement parts list. Replacement
parts can be purchased from your local hobby shop or by mail
order. If you need assistance locating a dealer to purchase
parts, visit www.aquacraftmodels.com and click on “Where
to buy”. If you are missing parts, contact Product Support at:
Phone: 217.398.8970
Fax: 217.398.7721
E-mail: productsupport@hobbico.com
Parts List
AQUB7760 3-Blade Metal Prop w/Nut
AQUB7860 Drive System
AQUB9205 Rigging Coupler (12)
AQUB9210 Rigging Line 5m Roll
AQUG7012 550 Motor
AQUM7040 ESC
TACM0235 TSX35 Standard Servo Sport
TACJ2490 TTX490 2.4GHz 4 Channel SLT Transmitter
(Surface)
TACL0400 TR400 2.4GHz 4 Channel Receiver