Attach a garden hose with a 3/4 in. garden hose thread
(not included) to the adaptor.
NOTE:
Be sure the 3/4 in. garden hose thread connector
has a rubber gasket to minimize water leaks.
NOTE:
The larger the inside diameter and the shorter the
length of hose, the less pressure that is lost (or the
larger the flow rate).
Connecting a 3/4 in. garden hose
Operating the pump
Place the pump on the pool cover or any place that you
would like to remove water. And plug the pump power
plug into a 115V outlet, protected with a 10 AMP fuse
or circuit breaker.
NOTE:
The pump will not start working unless water
level is over 2 in.
CAUTION:
This hole is for anti-airlock purposes only.
Leakage of air or water is normal and necessary.
DO NOT REMOVE OR PLUG THIS HOLE!
If you would prefer to use a 1-1/4 in. hose kit (not included)
in order to pump water away more quickly.
Securely attach the hose kit (not included) to the adaptor.
WARNING:
Secure the discharge hose before plugging in
the pump. An unsecured discharge hose may “whip”
possibly causing personal injury, and/or property damage.
Connecting a 1-1/4 in. hose kit
2a
2b
3
2
This pump is fully automatic in operation.
If the water level is over 2 in. , the water
detector senses water. Then the control
system built in the pump automatically
starts the pump and the pump continues to
run until water is pumped down to 3/8 in.
deep, and then it stops. If the water level is
lower than 2 in., the pump will not start.
NOTE:
Installing the adaptor and base
Attach the adaptor to the pump outlet.
NOTE:
Be sure the anti-airlock hole is upward.
Install the pump to the base.
base
1
anti-airlock hole
is upward
adaptor
YOU WILL NEED:
Tools:
Materials:
Screw Driver
Garden Hose
Sump Pump
Discharge Hose Kit
Wrench
Safety Goggles
Automatic Pool Cover Pump
Read your manual for installation, operation, and safety information.
This guide neither supplements nor replaces the Owner’s Manual.
Model: 53011-0
Quick Start Guide
© 2015 Copyright GP Enterprises Co., Ltd.
