Power up
Put the plug into the wall socket (switch the socket on if it’s switchable).
•
The light will come on, and the fan will start up - you may hear it in the background.
•
Initially, the light will be deep blue. It’ll change to be pale blue or white when the water in the
•
cooling unit has reached drinking temperature. This takes about an hour and a half, depending on
local conditions( temperature, humidity/pressure).
Cartridge life indcator
After you
fi
t a new
fi
lter, you must set the cartridge
•
life indicator so it can remind you when the
fi
lter
needs replacing.
The
fi
rst time you see the timer, the display will
•
be blank, to conserve the battery.
Every other time you need to set it, it’ll be
fl
ashing
•
continuously, to tell you the
fi
lter needs replacing.
The display has 6 parts: bulleye, inner ring, and 4
•
outer segments.
Using the tap
Wait till the light has changed from deep blue to pale blue or white before taking water from the
•
cooler.
Hold a suitable container against the tap to allow the water to
fl
ow.
•
As you take water from the cooling unit, it’s replaced by water from the water tank, so the light
•
may turn deep blue again.
The cooling unit holds about 1.2 litres of water, and the layer of water at the bottom of the wa-
•
ter tank, just above the cooling unit, will be almost as cold, so you can probably take about a litre
and a half before you lose the cool taste.
If you empty the cooling tank, wait until the light turns pale blue/white before taking any more.
•
RESET
top left
segment
outer
segment
outer
segment
press
inner ring
bullseye
4.
AQUA OPTIMA 30 day single life
fi
lter
a) Press and hold the RESET button for 4-8 seconds, then let go.
b) The top left segment will turn black, but only the bullseye will
fl
ash.
c) The outer segments will measure 7 days each, not 15 days.
d) When the
fi
lter comes to the end of it’s life, everything except the inner ring will
fl
ash.
e) Should you have any problems, refer to “ troubleshooting”, page 6.
Topping up
You may top the water up at any time, you don’t need to keep the
fi
lter submerged.
•
Try to keep the water level at least half way up to the water tank, as the head of the water in the
•
water tank provides the force that dispenses the water through the spout.
If the water level falls below the bottom of the water tank, the spout will dry up.
•
Emptying
There’s a drain plug underneath the cooling unit which must be unscrewed to empty the cooling unit
of the last 1.2litres of water (Fig.5).
a) Use up all the water in the water tank, and let it run dry.
b) Unplug the cooler.
c) Remove the lid, and lift out the
fi
lter holder (leave the
fi
lter attached to it).
AWD001 - Water dispenser_IM.indd 5
AWD001 - Water dispenser_IM.indd 5
2/13/2008 3:27:06 PM
2/13/2008 3:27:06 PM
