AQUA FORTE GFVS19N, Руководство по установке и эксплуатации

Страница: 11 / 37

9
•Air entering suction piping
•Basket full of debris
•Inadequate water level in pool
Pump being noisy
•Air leak in suction piping, cavitations caused by restricted or
undersized suction line or leak at any joint, low water level in
pool, and unrestricted discharge return lines.
• Disassemble pump, clean impeller, follow pump service
instructions for reassembly.
•Vibration due to improper mounting, etc.
9.
ERROR CODE
Note:
1. AL01 is not an error indication: when it appears the inverter will automatically switch to a
lower capacity to self protect against high internal temperature. When the temperature drops
back to 68
℃
the inverter will resume at the preset speed.
2. When causes for E002/E101/E103 lifts, the device will resume working automatically,
however when it appears a fourth time, the device will stop working, to resume operation,
unplug the device and plug in & restart again.
Item Code Description Analysis
1 E001 Abnormal input voltage Not faulty
2 E002 Output over current Not faulty
3 E101 Heat sink over heat Contact your supplier
4 E102 Heat sink sensor error Contact your supplier
5 E103 Master driver board error Contact your supplier
6 E201 Circuit board error Contact your supplier
7 E202 Master board EEPROM reading failure Contact your supplier
8 E203 RTC time reading error Contact your supplier
9 E204 Display board EEPROM reading failure Contact your supplier
10 E205 Communication error Contact your supplier
11 AL01 Auto speed reduction against high temperature Contact your supplier