aquabus X4
aquabus X4
aquabus X4
aquabus X4
aquabus X4
User and installation manual
User and installation manual
User and installation manual
User and installation manual
Description
Description
Description
Description
Active quadruple aquabus splitter.
For operation, an aquaero 5 or aquaero 6 device with firmware version 2100 or
higher is required. Compatible firmware versions are included starting with aqua-
suite version 2018-1.
Installation onto an aquaero 5/6
Installation onto an aquaero 5/6
Installation onto an aquaero 5/6
Installation onto an aquaero 5/6
The aquabus X4 is to be installed directly on top of an aquaero 5/6 device:
1. Turn off the PC, disconnect the aquaero from the PSU, disconnect the USB
cable, the standby power cable (aquaero 5 only) and aquabus high speed
cable from the aquaero if connected.
2. Remove the two screws adjacent to the temperature sensor inputs and to the
speed signal output from the aquaero.
3. Plug the aquabus X4 module onto the aquabus high speed connector of the
aquaero.
4. Secure both PCBs using the two cylindrical spacers and screws according to
the following figure. (The aquabus X4 can also be installed if a passive heat
sink is installed on the aquaero, in this case use the shorter spacers supplied
with the heat sink, replacement part number 91239.)
5. Connect aquabus high speed compatible devices to the aquabus connectors
of the aquabus X4 module. Reconnect PSU, USB and standby cables to the
corresponding connectors (if previously installed) and start the PC.
© 2018
Aqua Computer GmbH & Co. KG
94716
Gelliehäuser Str. 1, 37130 Gleichen
computer
aqua
