APV ISOBUS M2, Руководство по эксплуатации

Страница: 7 / 56

7
In the middle of the status bar, there is the APV logo. In case of errors, the logo is replaced
by the corresponding error or warning message.
On the right side of the status bar, there is the symbol for the current working position or
the current position of the mounted implement.
The mounted implement is in working position.
The mounted implement is not in working position.
Point 6.3.4 describes how the position or the utilised signal of the working position is changed.
5.1.2 STOP BUTTON
The STOP button can be found in every menu. This button executes a general STOP of all motors.
Figure 6
Description of the button functions
Grey: no actuators are switched on.
Red: motors are switched on and can be stopped with this button.
5.2 BASIC SETTINGS MENU
For initial operation or when pressing and holding the Set button in the Start menu for five seconds (see
also Point 6.1), the basic settings for the utilised seeder must be entered (e.g. settings for the implement
and fan type, seeding shaft motor, etc.).