OPT700/OPT700L Installation/User Manual
2
Important Safety Instructions
This manual contains important instructions to be followed during installation and
maintenance of the APsystems optimizer. To reduce the risk of electrical shock and ensure the
safe installation and operation of the optimizer, the following symbols appear throughout
this document to indicate dangerous conditions and important safety
instructions.
Specifications are subject to change without notice - please ensure you
are using the most recent update found at www.APsystems.com
WARNING:
This symbol indicates a situation where failure to
follow instructions may cause a serious hardware failure or
personal danger if not applied appropriately. Use extreme
caution when performing this task.
NOTE:
This symbol indicates information that is important for
Optimizer operation. Follow these instructions closely.
Safety Instructions
Do NOT disconnect the PV module from the APsystems optimizer
without first disconnecting the AC power.
Only qualified professionals should install and/or replace the APsystems
optimizer.
Perform all electrical installations in accordance with local codes.
Before installing or using the APsystems optimizer, please read all
instructions and cautionary markings in the technical documents and on
the APsystems microinverter system and the solar array.
Be aware that the body of the running APsystems optimizer is the heat
sink and can reach high temperatures. To reduce risk of burns, do not
touch the body of the optimizer.
Do NOT attempt to repair the APsystems optimizer. If it fails, contact
APsystems Customer Support to obtain an RMA number and start the
replacement process. Damaging or opening the APsystems optimizer
will void the warranty.
WARNING
SYMBOL
NOTE
SYMBOL