APS CPS100 Series, Руководство по эксплуатации

Страница: 155 / 231

CPS100 SERIES OPERATION MANUAL
SECTION 7:
Remote Control Programming
Entire Contents Copyright

2018 by Adaptive Power Systems, Inc. (APS) • All Rights Reserved • No reproduction without written authorization from APS.
APS CPS100 Series Power Source Operation Manual Page 155 of 231
Status Commands
Status commands are used to determine the state of the power source report on any error
conditions or faults.
Command Description
ASWRS? Returns last error code
ASWRC_0 This command clears all error codes. Also removes Fault pop-ups displayed
on LCD screen.
Table 7-4: Status Commands
Refer to tables below for a listing of all error codes for either Stand-alone mode or multi-
unit Master / Slave mode of operation.
Error Code Information Instruction
0x0100 INNER LVP Inner Under Voltage Protection
0x0080 INNER OVP Inner Over Voltage Protection
0x0040 RCP Reverse Current Protection
0x0020 SHT Short Circuit Protection
0x0010 FAN Fan Fault
0x0008 OTP Over Temperature Protection
0x0004 OPP Over Power Protection
0x0002
OCP Over Current Protection
0x0001 OVP Over Voltage Protection
0x0280 Frequency over 1.2kHz Input frequency BNC input > 1.2kHz
0x0210 Over range (mA) Over Range mA current range
0x0208
Over range (low) Over Range low current range
0x0204
Primary OCP Primary Over Current Protection
0x0202 Primary OTP Primary Over Temperature Protection
0x0201 Primary UVP Primary Under Voltage Protection
Table 7-5: Error Codes - Stand-alone Mode
Error Code Information Instruction
0x0401 Mode No Match Modes for Master/Slave don’t match
0x0402 Model No Match Model numbers are not the same
0x0404 No Phase B Missing Phase Slave unit B
0x0408 No Phase C Missing Phase Slave unit C
0x0410
Master Conflict More than one Master unit in system
0x0420 CAN No Slave No Slave unit found
0x0440 CAN No Master No Master unit found
0x0480 Slave Conflict More than one Slave with same number
0x0500
Slave offline Slave Unit off line
Table 7-6: Error Codes –Master / Slave Mode