APS CFS108, Руководство по эксплуатации

Страница: 46 / 146

CFS100 SERIES OPERATION MANUAL
SECTION 5: UNPACKING & INSTALLATION
Entire Contents Copyright

2016 by Adaptive Power Systems, Inc. (APS) • All Rights Reserved • No reproduction without written authorization from APS.
APS CFS100 Series Power Source Operation Manual Page 46 of 146
5.10 Output Terminals
The location and size of the AC or DC output terminals is model dependent. The rear panels
for each model are shown here for reference.
Note:
Always refer to Section 2.3 “Safety Information” and Section 2.4 “Safety Notices”
before making any load connections.
5.10.1 Model CFS108 Output Terminal Location
The output terminal block on the CFS108 is located on the far left side of the units when
facing the back. See illustration below. This terminal block requires the use of load wires
terminated with either a ring lug or spade lug. Both wire type and lug used MUST be rated
for the maximum available AC and DC current output capability of the CFS108.
Figure 5-8: CFS108 Output Terminals
5.10.2 Model CFS116 Output Terminal Location
The output terminal block on the CFS108 is located on the far left side of the unit when
facing the back. See illustration below. This terminal block requires the use of load wires
terminated with either a ring lug or spade lug. Both wire type and lug used MUST be rated
for the maximum available AC and DC current output capability of the CFS108.
Figure 5-9: CFS116 Output Terminals
LINE / +
Ground
NEUTRAL / -
LINE / +
Ground
NEUTRAL / -