APS 6RL Series, Руководство по эксплуатации

Страница: 23 / 204

6RL SERIES OPERATION MANUAL
SECTION 3: PRODUCT OVERVIEW
Entire Contents Copyright

2018 by Adaptive Power Systems, Inc. (APS) • All Rights Reserved • No reproduction without written authorization from APS.
6RL Series Regenerative DC Load Operation Manual Page 23 of 204
3.8 Remote Control Interfaces
3.8.1 USB Interface (standard)
The USB port on the rear panel of the unit is provided for remote control
and for firmware updates. The included USB cable can be used to connect
the unit to a PC (USB 2.0 or 3.0). The driver is delivered with the unit and
installs as a virtual COM port. Details about remote control can be found in
section 7 “Remote Control Programming”.
The unit can be addressed via this port using either the international
standard ModBus RTU protocol or by SCPI language. The unit recognizes the
message protocol used automatically.
If remote control is in use, the USB port has no priority over either the
interface module (see below) or the analog interface and should therefore
only be used in place of any of these. However, monitoring is always
available.
3.8.2 Interface Module Slot
One additional interface can be installed in the interface module slot on the
rear panel. These removable interfaces are easy to exchange in order to
change interface types. Details about the interface modules and the
programming of the unit using those interfaces can be found in section 7.
OPTIONS DESCRIPTION OPTIONS DESCRIPTION
OPT-232 RS232 Serial Interface OPT-ETH2P Ethernet/IP 2 Port
Interface
OPT-PBUS Profibus DPV1-
Interface OPT-PNET1P Profinet-IO 1 Port
Interface
OPT-CANO CANopen Interface OPT-PNET2P Profinet-IO 2 Port
Interface
OPT-DNET DeviceNet Interface OPT-CAN CAN Interface
OPT-MBUS1P Modbus-TCP 1 Port
Interface OPT-ECT EhterCAT Interface
OPT-MBUS2P Modbus-TCP 2 Port
Interface
OPT-ETH1P Ethernet/IP 1 Port
Interface
Table 3-2: Available Remote Control Interface Options
These modules are installed by the user and can be retrofitted without problem. A firmware
update of the unit may be necessary in order to recognize and support certain modules.
If remote control is in operation the interface module has no priority over either the USB
port or the analog interface and can, therefore, only be used alternately to these. However,
monitoring is always available.
Note:
Switch off unit before adding or removing modules!