Issue Date: 01.06.16
Review Date: 01.06.16
H0024 028626 A
Installation Manual for EHW Tanks: MAN_INST_TANK_SRT(AA)|6
CHAPTER 3:
SITE INSPECTION
3.1 STORAGE TANK LOCATION
The storage tanks are able to be installed indoors or
outdoors.
The storage tanks are to be installed at ground or
floor level and must stand vertically upright as the
manufacturer has intended.
The storage tank should be located as close as
possible to the most frequent draw off points in the
building such as the bathroom or kitchen. If the
storage tank is located a long way from hot water
draw points, a hot water circulation loop on a timer
may be considered to reduce the time-lag for water
to heat up and resultant water wastage.
The tank should not obstruct any windows, doors or
exits and should cause minimal intrusion to the
existing site. Clearances must be allowed for to make
servicing and maintenance convenient without the
need for ladder or scaffold. For servicing, the PTRV
must also be easily accessible.
For glass-lined tanks, consider the positioning of the
tank to allow room for anode removal and
replacement maintenance.
The storage tank must be installed in a properly
drained safe tray where leakage may otherwise cause
damage. The installation of the storage tank and safe
tray must comply with AS/NZS 3500.4 and all local
codes and regulatory authority requirements with
regards to its construction, installation and draining.
Tanks installed outside must be installed on a suitable
concrete slab.
The tank label must be clearly visible.
3.2 TRANSPORTATION AND UNPACKING
3.2.1 TRANSPORTATION OF COMPONENTS
When transporting boxes, note the orientation of the
"THIS WAY UP" arrows.
Ensure all boxes are strapped and secured to prevent
movement during transit.
All tanks must be transported upright. Stacking is not
recommended for any tanks.
Products should always be handled with care.
Damage incurred during the transportation is not
covered under product warranty.
3.2.2 UNPACKING OF COMPONENTS
When unpacking, take care to ensure that the
components are not damaged in the process.
Avoid using sharp blades or knives as this can scratch
the surfaces of the products particularly the tanks.