FLX-AES3
4.2.
Selecting the Route Mode
Long-press the
Mode
button until the LEDs are blinking yellow.
Current routing mode is shown by alternately yellow blinking LEDs, indicating
the interfaces where the signal is passed between.
Press the
Mode
button repeatedly to cycle between available modes, until
the desired mode is shown.
After four seconds without interaction, selection mode is terminated and the
current setting comes into effect.
4.3.
Remarks
Routing between the selected interfaces is always bi-directional, meaning that
audio is passed between them both ways. A working bi-directional link shows
⬤
green for both interfaces. If the LED shows
⚪
white, the corresponding
interface does only output data but no input on it has been detected. If the LED
shows
⬤
red, the interface is not connected, or the clock is invalid or missing.
When routing channels to the AUX or FlexLink interface, channels of AES3 Port
A and B are concatenated together and appear on the FlexLink interface
channels 1-16 and vice versa. The channels of the AUX card can either be
mapped to the FlexLink interface directly after that (commencing at channel
17), or to a different block. See
FlexLink channel mapping (DIP3, 7..9)
.
Channel-wise routing and splitting (crosspoint switch/matrix) between all
channels is possible when the flexiverter is connected to a multiverter. Routing
is then done via the multiverter's web interface or via the command line.
9
