600840-000031 Stratus ES/ESG Installation Instructions
Rev. 2.1
Last Revised: June 22, 2017
Page 15 of 44
1.10.
Required hardware
The following parts are required for the installation of Stratus ES/ESG.
Supplied parts:
Item
Appareo Part
Number
Commercial Part
Number
Quantity
Backplate
153510-000015
-
1
Stratus ES Transponder
or
Stratus ESG Transponder
153510-000069
or
153510-000017
-
1
Stratus ES/ESG Rack
153540-000027
-
1
37 Pin DSUB Connector
251015-000074
M24308/2-4F
1
RF TNC Pass Through Adapter
(Stratus ESG only)
251015-000077
-
1
RF BNC Pass Through Adapter
251015-000078
-
1
Screw
356060-000007
-
6
Strain Relief Backshell
356070-000006
M85049/48-1-4F
1
Table 10: Required hardware (supplied parts)
Additional parts:
Item
Appareo Part
Number
Commercial Part
Number
Quantity
#6-32 x 100° Flat Head SS
Screw
-
MS24693C, AN507R
or other approved
fastener
6
Metal Hex Stop Nut *
-
MS21042-06
6
Monadnack Clip Nut 6-32*
-
294667
6
Table 11: Required hardware (additional parts)
*These parts are identified as usable components, but are not identified as the only components
that can be used. Installer must determine if the part is appropriate for specific installation or if
an alternate part is required.
1.11.
Compatible equipment
Stratus ES/ESG requires input from the following:
Transponder antenna
GPS position source (Stratus ES) or GPS antenna (Stratus ESG)
Altitude encoder
This section describes the requirements for this equipment. Inputs from systems described
below may be pre-existing. If these systems do not exist or have specifications outside those
described, selection of new equipment will be required. These installation instructions do not