RoadRunner HDX
™ | Rapid Deployment Kit High Definition Portable Mobile Recording System
8
Chapter 3 — Operation and Configuration
NOTE: The Recorder should be completely installed before proceeding. Refer to Chapter 2
—
Installation.
Turning on the Power
The Recorder can be turned on by inserting the power cable with the drive door
closed. The Recorder is operational in approximately 60 seconds. The Power LED on
the front panel will illuminate and this action signifies the Recorder has been turned
on properly
.
NOTE: The recorder will delay powering the system until the Smart Storage Modules have heated to above 18°C,
this could take up to 20 minutes when temperatures are below -20°C.
WARNING: DO NOT TOUCH THE BOTTOM OR TOP OF THE REMOVABLE DRIVE WHEN REMOVING
IT AFTER THE HEATER HAS BEEN OPERATING IN LOW TEMPERATURES. DURING
OPERATION OF THE HEATER, THE TEMPERATURE OF THE DRIVE MAY INCREASE
CAUSING INJURY.
Initial Unit Setup
Before using the Recorder for the first time, establish the initial settings. Install the RsM Software Program
(RoadRunner Secure Management Software
TM
) on a PC and connect to the Recorder remotely.
The RsM program is provided with the product for remote operation. The Recorder can be accessed,
configured and managed by using RsM. The recording system is connected remotely via network
connection. The RsM Program allows set up of the Recorder, to monitor video of the Recorder and play
back video recorded on the system.
NOTE: Refer to the RsM Software manual for instructions on how to install the program and connect the
Recorder remotely.