APEXRA APHP-12-2, Руководство по обслуживанию, установке и эксплуатации

Страница: 8 / 48

Page 8
ASSEMBLY
1. Screw legs into the permanently fastened nu t s on the four corners of the unit and tighten by hand.
2. Level the unit by turning the adjustment sc r ew at the bottom of each leg . Do not slide unit with l egs mo u nted; lift to
move the u ni t.
CAUTION
DO NOT use an open flame t o check for leaks.
Check al l gas pip i ng for leaks with a soap and wa t e r solution before operat ing uni t .
A qualified installer who tho r ough ly r eads , u n derstands and follows these instructions should perform i nstal l a ti o n .
Installation mu st confor m with l ocal codes, o r in the absence of l ocal co d es, with th e
Nat i onal Fuel Gas Code, ANSI
Z223 . 1 /N FPA 54 , Liqu efie d P e trol e um Ga s Code ANSIINF P A 58, CSA- B149 .1,
or t he
Propan e I nstallation Code, CSA-
B149 .2
as app l icable an d i n acco rd ance wi th loca l codes.
Th e app l ia n ce and it s ind i v i dual shutoff va l ve (to be supp l ied by user) must b e disconnected from the gas suppl y piping s y stem
duri ng a n y pressure tes ti ng of th at system at test pre ssu r es in excess o f ½ psi (3 .5 kPa).
The app l iance mus t b e isolated from t h e gas su pp l y piping sys t em by closing its indi vidua l manual s h ut-off valve du r ing any
p r ess ur e testing of the gas suppl y piping s y s t em at test press u res eq u a l to or l ess th an ½ ps i (3 .5 kPa).
•
The i ns t alle r must i nclude a manual valve t o shu t off the fu el supply into the app l iance.
•
Pipe thread seal i ng compound must b e r esis t an t t o the act i on of l iquefied petroleum gases.
•
Verify that the product regula t o r and or i f i ce matc h gas typ e (natura l gas o r L P G -propane) .
•
Adjust pilot if necessary.
•
Adj u st main burner(s) i f necessary.
•
Adjust ma in burn er air shutte r if necessary.