Apcon ACI-3144-XR, Руководство пользователя, Страница: 58 / 90

APCON, Inc. 58 A54-3144-XR • Rev B
Chapter 5. Configure the chassis ACI-3144-XR Chassis User Manual
About
To access the Switch Information screen, press DOWN to scroll through the Main Menu.
Highlight the About sub-menu, then press ENTER . The following screen is displayed:
The following table describes the information listed on the Switch Information screen.
Information Description
Name Name you specify for the chassis using W
EB
XR or CLI. The default is
Unnamed
. To change the chassis name, use either W
EB
XR or CLI (see
Name the chassis (optional)
on page 62).
Model Model number for the chassis.
Software Current version number of software installed on the Active Controller.
IP n IP address configured for the chassis.
If the IP address is not configured, the display is “n/a”.
Netmask n Subnet mask configured for the chassis. The default is
255.255.255.0
. If Netmask2 is not configured, the display is “n/a”.
Gateway n Network gateway address for the chassis. The default is no gateway
(
0.0.0.0
). If Gateway2 is not configured, the display is “n/a”.
MAC n MAC address of the LAN1 or LAN2 port.
BP Serial Backplane serial number.
Act Model Active Controller—model number.
Act Serial Active Controller—serial number.
Act Date Active Controller—manufacture date.
Stby FW Current version of software installed on the Standby Controller.
Stby Model Standby Controller—model number.
Stby Serial Standby Controller—serial number.
Stby Date Standby Controller—manufacture date.
Stby IP n IP addresses for the Standby Controller. If the Standby Controller’s LAN
interfaces are not configured, the display is “n/a”.