Apcon ACI-3144-XR, Руководство пользователя, Страница: 50 / 90

APCON, Inc. 50 A54-3144-XR • Rev B
Chapter 5. Configure the chassis ACI-3144-XR Chassis User Manual
2. To set the desired gateway, use the CANCEL and ENTER buttons to position the cursor
over the first digit you want to change.
• To move the cursor to the right, press
ENTER .
• To move the cursor to the left, press CANCEL .
3. When the cursor is positioned over a digit you want to change, press either UP or
DOWN to increase or decrease the value.
4. When the desired digit is displayed, press ENTER to confirm the setting and move the
cursor to the right over the next digit.
5. Repeat the steps above until the desired gateway is displayed.
6. When the desired gateway is displayed, press ENTER repeatedly until the cursor
moves all the way to the right and the IPv4 Menu is redisplayed.
7. To save the gateway address, press DOWN repeatedly until the Save Changes option
is marked on IPv4 Menu , and then press ENTER .
Configuration > IPv6 Config
To access the IPv6 Menu , press DOWN to scroll through the sub-menus on the Config
Menu until the IPv6 Config menu is selected, then press ENTER . The following screen is
displayed:
This menu lists sub-menus that allow you to set IPv6 parameters for the chassis.
IPv6 Sub-menu Description
IPv6 Enable Enables an IPv6 address for the chassis.
LAN1 IPv6 Addr Sets the IPv6 address on the chassis to an available static
IPv6 address on the network. The controller supports two
LAN ports:
• You must set an IPv6 address for the LAN1 port to be
able to access the chassis over a network.
• Setting an IPv6 address for the LAN2 is optional.
LAN1 Prefix Sets the subnet prefix length.
LAN1 Gateway Sets the gateway address for the chassis.