PXQ2215
OWNER’S MANUAL
SLIMLINE
SLIMLINE
SLIMLINE
SLIMLINE
• Read all documentation before operating your equipment.
Retain all documentation for future reference.
• Save the carton and packing material even if the equipment has arrived in good condition.
Should you ever need to ship the unit, use only the original factory packing.
• Do not spill water or other liquids into or on the unit.
• Make sure power outlets conform to the power requirements listed on the back of the unit.
• Do not use the unit if the electrical power cord is frayed or broken.
• Always operate the unit with the AC ground wire connected to the electrical system ground.
• Have gain controls on amplifiers turned down during power-up to prevent
speaker damage if there are high signal levels at the inputs.
• Do not connect the inputs / outputs of amplifiers or consoles to any other voltage source,
such as a battery, mains source, or power supply, regardless of whether
the amplifier or console is turned on or off.
• Power down & disconnect units from mains voltage before making connections.
• Do not use the unit near stoves, heat registers, radiators, or other heat producing devices.
• Do not block fan intake or exhaust ports. Do not operate equipment on a surface or in an
environment which may distort the normal flow of air around the unit. If the unit is used in an
extremely dusty or smoky environment, the unit should be periodically "blown free" of dust.
• Do not remove the cover. Removing the cover will expose you to potentially dangerous voltages.
• Do not drive the inputs with a signal level greater than that required to drive equipment
to full output.
• Do not run the output of any amplifier back into another input.
• Do not ground the red output terminal, never connect a red output terminal to
another red output terminal.
• In case of mal-function this device should be serviced by qualified service personnel only.
SAFETY INFORMATION
!!
C A U T I O N
TO REDUCE THE RISK OF ELECTRIC SHOCK
DO NOT REMOVE COVER OR BACK
NO USER-SERVICEABLE PARTS INSIDE
SERVICING ONLY FOR QUALIFIED PERSONNEL
EQUALIZER & X-OVER
EQUALIZER & X-OVER
2 X 15, 2/3 & 1/3 ocatve combined
35 - 400Hz adjustable
24dB/oct Linkwitz - Riley
+/- 6dB or 12dB selectable
Balanced XLR 20Kohm, RCA cinch 15Kohm
Sub out / High pass fullrange out : XLR ba RCA cinch
0.02% (at 1KHz all sliders at center)
20 Hz to 50KHz
>93dB
44 X 483 X 280 MM
Net. 2.8 Kg
Type
X-over
Control range
Inputs
Outputs
Distortion
Frequency Response
Signal to noise ratio
Dimensions (H x W x D):
Weight
PXQ2215
