HDMI-IP-E and HDMI-IP-R
APANTAC LLC,
10200 SW Allen Blvd. Suite C, Beaverton, OR 97005 USA
, TEL: +1 503 968 3000, FAX: +1 503 389 7921
22
Fig 9-2: Set IP properties
Important Notes:
1.
For the HDMI-IP-E(TX) and HDMI-IP-R (RX) communicate and find each other, the
Multicast IP address must be set to the same.
2.
When the webpage is first launched, the Multicast IP address is read back from
the HDMI-IP-E/R (Tx/Rx)’s Multicast ID Settings.
3.
If the Multicast IP is set in the Webpage, then the webpage setting will overwrite
the hardware DIP switch setting, until the Tx/Rx has been power cycled
4.
The OSD will reflect the last Unicast IP setting regardless it is done by webpage or
DIP switch
9.3 Setting the Multicast ID and IP address
Fig 9-3: Multicast IP setting is read back from the HDMI-IP-R
9.4 Set Baud Rate
The Uart (RS-232) baud rate setting can be set by either the webpage or the DIP switch.
The baud rate setting must be set the same for the HDMI-IP-E and HDMI-IP-R
Fig 9-4: Set RS232 baud rate
