Apach BAKERY Line L 120, Инструкция по эксплуатации и техническому обслуживанию

Страница: 70 / 126

70
EN
Adjustment of the belt tension and replacement of the transmission belts
The tension of the transmission belts must be adjusted when the rotation of the spiral tool/bowl slows
down or is not smooth during the execution of a work cycle.
It is obligatory to:

wear protective clothing suitable for the task to be carried out,

switch off the machine and disconnect it from the power supply, before carrying
out any operation on the machine.
The procedure for the adjustment of the belt tension and replacement of the transmission belts is
described in Appendix 3.
Note: Before replacing the belts, ensure that the new belts have the same characteristics as the original
belts installed on the machine by the manufacturer.
11. DESCRIPTION AND MAINTENANCE OF THE HYDRAULIC UNIT
Any type of intervention on the machine must be carried out by suitably
qualified personnel, using suitable equipment and in accordance with the
local safety standards and regulations in force!
Before carrying out any operation on the machine, it is obligatory to:

wear protective clothing suitable for the task to be carried out,

switch off the machine (by turning off the main switch) and
disconnect the machine from the power supply, ensuring that the
electrical panel on the machine and the machine power cable are isolated
from the main power supply in a safe manner for the entire duration of
the intervention, without accidental risk of re-energising of the power
supply.
11.1 Description of the hydraulic unit
Part number:
R06001
Motor: 0,75 kW
Type of pump: "N" PHC 1-3,8 cm3/g x MC
Working pressure: 110 bar
Access can only be gained to the hydraulic unit after having removed the corresponding machine
column casing.
Refer to the attached hydraulic unit manual supplied by the hydraulic unit manufacturer for additional
instructions realtive to the maintenance.