AP Expert VT-110, Руководство пользователя

Страница: 18 / 84

Chapter 5: Getting Started
NOTE: This menu is accessible if the humidity probe is enabled.
2. Set the following parameters:
Minimum
ventila-
tion
The controller can compensate for high humidity levels by increasing the minimum ventilation
intensity. Select
Yes to use this compensation method
Heater The controller can compensate for high humidity levels by activating heating outputs in timer
mode. Select
Yes to use this compensation method
Mist
shutoff
The controller can deactivate the misting output when humidity levels are too high. Select Yes
to use this compensation method. *This applies to cooling stage and to fan stage 3-8 relays
that are configured in timer mode
Mist on
low % RH The controller can activate misting outputs when humidity levels are too low. Select Yes to use
this compensation method
Setting the Daytime and Nighttime Parameters
The controller allows you to set different temperature setpoints and different minimum ventilation settings
during the night and during the day.
1. Using the menu select arrow keys, navigate to User→Day / Night .
2. Set the following parameters:
Night Setpoint Select Yes to use a different target temperature at night; select No to dis-
able this function.
Night Minimum Ventilation Select Yes to change the minimum ventilation fan speed at night; select No
to disable this function.
Day Time Set the time at which day settings begin. *Accessible if a night function is
enabled above.
Night Time Set the time at which night settings begin. *Accessible if a night function is
enabled above.
Transition
If the night set point is enabled above, a transition is made from one set
point to the other. Set this transition time to the desired value.
Configuring the Installation
Configuring the installation allows you to customize the controller for your particular application. It shows
how to enable and set the outputs of your controller. Normally, this setup needs to be done only once.
1. Using the menu select arrows, navigate to User→Installation .
2. Set the following parameters:
Number of feeders Enable the proper number of feeders (0 to 4 feeders)
Number of heater
stages Enable the proper number of heating stages (0 to 2 stages)
Use HI fire Select Yes to activate the heating output Hi fire option. This function allows to acti-
vate additional heater outputs
Number of fan stages Enable the proper number of fan stages (3 to 8 stages)
18 890-00081 Expert VT-110