AC-135 User Manual
(page 1)
c. Link to Remote
1. Link the Shade to the Remote Control
(if you are adding multiple shades to a controller, see instructions at bottom of Page 2)
Press the
UP
button on the
Remote once.
The shade rotates
briefly up and
down.
Test
UP/STOP/DOWN
buttons once
each.
2. Set Upper position for the shade
(wait 30 seconds if just completed Step 1)
b. Press/hold the Program button
With a paper
clip or small
screwdriver,
PRESS and
HOLD BUTTON
until shade
rotates briefly
up and down
a. Bend a paperclip to
PRESS/HOLD
the inset
button on the
BACK
of
the control, until the
shade rotates briefly
up and down
3. Set Lower positions for the shade
(wait 30 seconds if just completed Step 2)
b. Use a paperclip
to
PRESS/HOLD
the
button on the BACK
of the remote, until
the shade rotates
briefly up and
down
c. Press the
UP
and/or
DOWN
buttons until the
shade is at the
desired position.
d. Use a paperclip to
PRESS/HOLD
the
button on the BACK
of the control, until
the shade rotates
briefly up and down
a.
PRESS/HOLD
the
DOWN
button 3
seconds to start the
shade down. Press
STOP
when the shade
is near the desired
lower position.
Notes
: If action between steps (a, b, c) takes longer than 30 seconds, the program will not complete. Simply start each step again at sub-step ‘a.’
Up to 4 intermediate stops can be set by following Step 3 for each. IF the shade does not follow commands, DELETE all Memory (next page) and start over.
FCC Notice:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause undesired operation.
a. Select the Channel
(for Multi-Shade remotes)
Press the
RIGHT/LEFT
buttons to select
desired channel
(start on 1, then can
add others)
.
Select a single
channel, not ALL
(ALL=all lights on)
IF shades moves in reverse:
Wait 30 seconds since
last command.
PRESS/HOLD
the
STOP
button for 5 seconds
until the shade rotates
briefly up and down.
Press the
DOWN
button
once. The shade rotates
briefly up and down to
signal reversed direction.
b. Press the
UP
and/or
DOWN
buttons until
the shade is at
the desired top
position.
c. Use a paperclip to
PRES
S
/HOLD
the
button on the
BACK
of the remote, until
the shade rotates
briefly up and down.
