Anywave PA-U1D-C-FA, Руководство пользователя

Страница: 6 / 22

PA-U1D-C-FA User Manual
ACT-PA-U1D-USR-DOC-V2.2, 09/25/2019 Page 6 of 22
1 Product Appearance
1.1 Front Panel

LED_PWR

The green light will be on when the DC voltage of the internal power supply is within the normal
range (48 VDC ~ 52 VDC).

The green light will flash when the DC voltage of the internal power supply is out of the normal
range (48 VDC ~ 52 VDC).

The green light will be off when the external power supply is turned off, or the internal power
supply module does not work.

LED_RS485

The green light will stay on when internal communication is normal.

The green light will stay constantly off when internal communication is abnormal.

LED_FWD

The blue light will be on when RF_OUT has power output.

The blue light will be off when the RF button is turned off, or the PA enters the auto-protection
mode and therefore shuts down its RF output. There are several situations which will result in
auto-protection mode, such as the input power is too high, the reflected power is too high, or the
temperature is too high.

LED_ALARM

The red light will be off if there is no alarm.

The red light will be on if there is an alarm.

LAN

Connector:10M/100M Ethernet

Note: Ethernet port for web-based remote control (IP address: 192.168.1.210,
username/password: anywavecom/anywavecom)

RESET

Press for up to 8 seconds to reset the IP of the amplifier to default (192.168.1.210).