VERTICAL CONTACT TOASTER
6
P/N 1010838 Rev. D 07/06
Burger King
WARNING
ELECTRICAL SHOCK HAZARD. FAILURE TO
FOLLOW THE INSTRUCTIONS IN THIS MANUAL
COULD RESULT IN SERIOUS INJURY OR DEATH.
• Electrical ground is required on this appliance.
• Do not modify the power supply cord plug. If
it does not fit the outlet, have a proper outlet
installed by a qualified electrician.
• Do not use an extension cord with this appli-
ance.
• The toaster should be grounded according to
local electrical codes to prevent the possibil-
ity of electrical shock. It requires a grounded
receptacle with separate electrical lines pro-
tected by fuses or a circuit breaker of the prop-
er rating.
• Check with a qualified electrician if you are in
doubt as to whether the appliance is properly
grounded.
CAUTION
All electrical connections must be in accordance
with local electrical codes and any other appli-
cable codes.
CAUTION
Bread may burn. Therefore toasters must not be
used near or below curtains or other combustible
walls and materials. Failure to maintain safe oper-
ating distances may cause discoloration or com-
bustion.
Unpacking
1. Remove unit and all packing materials from
shipping carton.
2. Open the included large box. It should contain
the following:
• Bun Chute (Figure 1)
• Bun Feeder (Figure 1)
• 2 Release Sheets (Figure 1)
• Owner’s Manual
• Maintenance Card
• Authorized Service Agency Directory
3. Remove all shipping tape and protective cover-
ings from the unit and parts.
NOTE: If any parts are missing or damaged, con-
tact Antunes Technical Service IMMEDIATELY at 1-
877-392-7854 (toll free in the U.S.) or 630-784-1000.
Equipment Setup
Before placing the toaster into service, pay attention to
the following guidelines:
• Make sure power to the unit is off and the toaster
is at room temperature.
• Do not block or cover any openings on the unit.
• Do not immerse cord or plug in water.
• Keep cord away from heated surfaces.
• Do not allow cord to hang over edge of table or
counter.
• Connect the unit to the proper power supply.
Refer to the specification plate for the proper volt-
age
Assembling the Unit
NOTE: The factory has pre-installed a Release
Sheet over the Platen (Figure 1). Verify that it is
properly in place before proceeding.
INSTALLATION
1. Remove Bun Chute and Bun Feeder from the
box and install (Figure 1).
IMPORTANT: Make sure Heat Shield Assembly is
activating the conveyor interlock switch (see Figure
1). The conveyors will not rotate unless the Heat
Shield is in place and interlock switch is activated.
CAUTION
Failure to use Release Sheets may result in dam-
age to the unit and loss of warranty coverage.
