VERTICAL CONTACT TOASTER
12
P/N 1010838 Rev. D 07/06
Burger King
Daily
CLEANING THE BLACK AND SILVER RELEASE SHEET,
CONVEYOR BELT WRAPS, AND TOASTER
Tools Required:
• Heat resistant gloves
• Clean towels
• Capital® Multipurpose Superconcentrate
• Sanitizer Solution
1. Turn the Rocker Switch (power On/Off) to OFF,
unplug the power cord, and allow the unit to cool
for 30 minutes.
2. Put on heat resistant gloves. Remove the Bun
Feeder, Heat Shield, and Bun Chute (Figure 1).
Wipe them with a damp sanitized towel and allow
them to air dry.
3. Remove the Release Sheet and place it on a
clean, flat dry surface. Wipe the silver side
with a
clean
towel (or approved no-scratch
pad) dampened with
Capital® Multipurpose
Superconcentrate (HSC)
(or other approved
cleaner) immediately followed by a second clean
towel dampened with sanitizer and allow it to air
dry before continuing. Repeat this step on the
black side of the Release Sheet once the silver
side is dry.
4. Open the front Conveyor Cover and firmly wipe
the black cleated Belt Wrap from left to right and
top to bottom with a clean towel (or approved
no-scratch pad) dampened with
Capital®
Multipurpose Superconcentrate (HSC)
(or other
approved cleaner)immediately followed by a sec-
ond clean towel dampened with sanitizer.
MAINTENANCE
WARNING
Turn the unit off, disconnect the power source
and allow the unit to cool down 30 minutes before
performing any service or maintenance on the
unit.
CAUTION
To prevent damage to the unit, do not use abra-
sive cleaners on the Release Sheet or belt wrap.
CAUTION
Failure to use Release Sheets may result in dam-
age to the unit and loss of warranty coverage.
5. Close the front Conveyor Cover, open the rear
Conveyor Cover, and clean the Belt Wrap as
described in Step 4.
6. Close the rear Conveyor Cover, Reinstall the
Heat Shield, plug in the power cord, turn the unit
on, count 10 seconds, then turn the unit off and
unplug the unit.
7. Open the rear Conveyor Cover again, clean the
newly exposed section of the Belt Wrap in the
same manner as before. Close the Conveyor
Cover.
8. Open the front Conveyor Cover again and clean
the newly exposed section of the Belt Wrap in the
same manner as before.
9. Close the front Conveyor Cover and wipe down
the outside of the toaster with a clean, damp,
sanitized towel.
10. Install the Release Sheet by draping it over both
sides of the Platen with the crease centered on
the Platen.
NOTE: Rotate from the black side to the silver side
daily or weekly to prolong the life of the Release
Sheet.
11. Install the Bun Chute so the hooks are installed
over the lover rear yellow Support Rod. Install
the Heat Shield with the Release Sheet retainer
clips securely over the Release Sheet and
Platen.
12. Reinstall the Bun Feeder and plug in the unit.
Important! Make sure the Heat Shield is activat-
ing the Conveyor Safety Interlock Switch. The
Conveyors will not rotate unless the Heat Shield is
in place and the Conveyor Safety Interlock Switch
is activated.
Note: Check the Release Sheet to make sure it is
not caught in the Conveyor. Additional release
Sheets can be obtained through your Authorized
Service Agency under P/N 7000249 (3 Pack) or
7000250 (10 Pack).
