Anton Paar TTK 600, Справочное руководство

Страница: 53 / 85

8 Performing a Measurement
D52IB001EN-G 53
8.4 Mounting the Sample Holder
8.4.1 Mounting the Standard Sample Holder
In order to mount the standard sample holder pro-
ceed as follows:
1. Insert the sample holder in the groove of the
sample holder fixing ring (1) while guiding the
cable of the Pt100 (2) behind the heating/cool-
ing block.
2. Use the Torx screw driver that was delivered
with the instrument to fix the sample holder to
the fixation ring by tightening the screw (3) until
the first click of the Torx screw driver occurs.
(corresponds to a force of 1.1 Nm)
3. Connect the Pt100 to the Pt100 plug connector
(4).
4. Switch on the heater of CCU 100.
Fig. 56: Standard Sample Holder
1 Sample holder fixing ring
2 Pt100
3 Fixing screw
4 Pt100 plug connector
8.4.2 Mounting the Standard Sample Holder
Heating Environment
To mount the sample holder environment proceed
as follows:
1. Remove the sample holder.
2. Remove the cooling equipment from the instru-
ment.
3. Demount the heating/cooling block of the instru-
ment from the housing by unscrewing the
knurled screws as shown in the following pic-
ture. Take care to hold the heating block while
unscrewing the last screw. (Should the knurled
screws at the bottom be stuck, use the supplied
Torx 10 to loosen them.).
4. Place the heating/cooling block on the delivered
stand as shown in the picture.
5. Remove the sample holder fixing ring by
unscrewing the two screws with the supplied
Torx driver.
NOTICE
Risk of damage
Make sure the graphite foil for heat conduction is
not scratched. Deep scratches will cause insuffi-
cient heat transfer which will eventually lead to
severe damage of the heating system.
For changing the graphite foil refer to the service
manual of TTK 600.
1
2
3
4