Anton Paar TTK 600, Справочное руководство

Страница: 38 / 85

6 Operating CCU 100
38 D52IB001EN-G
6 Operating CCU 100
This chapter describes the operation of the
CCU 100 Combined Control Unit. CCU 100 can be
operated manually or by remote control.
• Manual control is done with the keys on the front
panel of CCU 100. Manual operation is
described in chapter 6.6 Manual Control of
CCU 100.
• Remote control is done with a computer inter-
faced to CCU 100 via the serial RS 232 inter-
face and with suitable software. See chapter 6.7
for more information.
CCU 100 can only store one target value for tem-
perature and heating/cooling rate at a time. Pro-
gramming temperature profiles into CCU 100 is not
possible on the controller itself. However, the deliv-
ered software for the controller allows to program a
temperature profile (see the corresponding software
manual that was delivered with the instrument).
6.1 Front Panel of the Instrument
The front panel of CCU 100 contains the keypad,
the status LEDs and the display which are described
in the following section.
Fig. 42: Front panel of CCU 100
6.2 Keypad
The keypad of CCU 100 has 6 keys to select param-
eters and enter values.
Fig. 43: Keypad of CCU 100
No <Key> Function
1 SCROLL Switches to next parameter.
2 UP Increases the value of the
currently displayed parame-
ter.
3 DOWN Decreases the value of the
currently displayed parame-
ter.
4 HEATER Switches the heater on and
off.
5 SELECT Short: selects a parameter.
Long: selects a slot.
6 RESET Resets an error.
1 2 3 4
5
6