Last updated: 12/15/2013
Page 1 of 4
AntMiner FAQ
Q: How to reset antMiner to the default state?
A: S2 is the reset button in the second version of control board, but there is no reset button in the
first version of control board. If AntMiner has to be reset, please follow these steps.
Step 1: Set your PC’s IP address as 192.168.2.x or 192.168.1.x, and then connect AntMiner with
your PC via a network cable.
Step2: Power on AntMiner for a while when it is in the normal state. The WAN LED should be light.
Step3: For the second version of control board, please press button S2 for more than 3 seconds.
For the first version of control board, please short the RESET PIN to 3.3V as the following picture
for more than 3 seconds.
Step4: Re-power antMiner. Ping 192.168.2.99 or 192.168.1.99. Note: from the version 20131212
of openwrt, the default IP is 192.168.1.99
Figure 1 Second batch of control board
