Anthem MRX 300, Руководство по эксплуатации

Страница: 15 / 52

7
2.1 VIDEO CONNECTIONS
To configure inputs see section 3.5 and to configure video outputs see section 3.1.
HDMI:
Video is sent with audio from source components to the receiver. Maximum video resolution is 1080p60.
Connect MAIN HDMI output to a display with HDMI or DVI input – one with High-bandwidth Digital Content
Protection (HDCP) is required to display copy-protected material. Disc players usually enable HDCP even on
home movies.
Before calling for technical support due to bad, intermittent, or no picture via HDMI:
1080p uses twice the bandwidth that 720p and 1080i do – make sure that the cable is suitable for the
application otherwise the picture may contain pixel dropouts or not play at all.
Use HDMI Category 2 cables, also known as “v1.3 certified”. This is a requirement for all connecting
devices including extenders when connecting a display that supports Deep Color (10- or 12-bit).
Connecting devices that worked in an older setup may not work with Deep Color. If the source allows
Deep Color to be turned off, start troubleshooting by turning it off.
12-bit Deep Color that works at 1080p24 may not work at 1080p50 or 1080p60.
Be careful when connecting HDMI cables. The connector should easily slide in the jack – do not insert
it on an angle and do not force it. Each connector contains 19 delicate pins and damaged pins can
damage jacks. Such damaged jacks are not covered by warranty. If your HDMI cables have been
connected enough times that they are about to wear out, we recommend that you replace them.
If using DVI connection note that cables with DVI connection on one end and HDMI connection on the
other are more reliable than DVI-HDMI adapters. If you are having a connection problem and an adapter
is in use, start troubleshooting by eliminating the adapter.
Cable and satellite receivers: Some disable their component video output once HDMI is connected. To
use the cable/satellite box in a secondary zone that uses component video, connect the box to the
receiver via component, not HDMI.
Older cable and satellite receivers: HDMI connection may be problematic especially when output
resolution changes between SD, 720p, and 1080i according to the channel. In such a case use
component video connection instead, with coaxial or optical connection for audio.
Component Video:
Component video uses three coaxial cables and has a maximum resolution of 1080p when unprocessed or
480p when the source is copy-protected with Macrovision. Maximum input resolution is 1080i60 if the input
is processed or converted to HDMI.
Composite Video:
Maximum resolution is 480i (NTSC) / 576i (PAL). This traditional format combines the black/white and color
information for transmission on a single coaxial cable. To be displayed, the information has to be separated,
a process that degrades video quality.
2. CONNECTIONS