xv
Antaira Technologies - Industrial Ethernet Switches
LMP-1202M-SFP Series Hardware Manual V1.0
2.7 Wiring the Power Inputs
Caution: Please follow the steps below when inserting the power wire.
1. Insert the positive and negative wires into the PWR1 (V1+, V1-) and PWR2 (V2+, V2-) contacts
on the terminal block connector as shown below in
Figure 2.12
.
Figure 2.12 - Power Terminal Block
2. Tighten the wire-clamp screws to prevent the wires from loosening, as shown below in
Figure 2.13
.
Figure 2.13 - Power Terminal Block
Note
•
Only use copper conductors, 105.7°C, tighten to 7 in-lbs (0.8 Nm).
•
The wire gauge for the terminal block should range between 18~20 AWG.
•
Use conductors with insulation rated for at least 105.7°C.