Antaira Industrial Ethernet Switches
LMP-0501 Series User Manual V1.0
1
1. Introduction
Antaira
Technologies’ industrial managed switches come with a pre-installed “user friendly” web
console interface, which allows users to easily configure and manage the units, whether one is using
a serial console and command line interface(CLI) commands like Telnet, SSH, HTTP (Web GUI) or
simple network management protocols (SNMP).
1.1 Product Overview
Antaira
’s LMP-0501 series
is a 5-port industrial PoE+ managed Ethernet switch that is
embedded with four 10/100Tx Ethernet ports that support either IEEE802.3af or IEEE802.3at for
a maximum of 30 watts per port, and one 100Fx (SC or ST type) fiber port in a multi-mode(2Km)
or single-mode (30Km) option. It is a fully manageable industrial Ethernet switch that supports the
standard Layer 2 Ethernet configurable settings. This product series is IP30 rated and DIN-rail
mountable. There are two operating temperature models, either the STD: -10°C to 70°C, or the
EOT: -40°C to 75°C. It also provides high EFT and ESD protection for any industrial networking
application within factory automation, ITS, power/utility, water wastewater, and any other outdoor
or harsh environment.
1.2 Product Software Features
Network Redundancy
STP, RSTP, MSTP, ITU-T G.8032 Ethernet Ring Protection Switch (ERPS) for
network redundancy
Network Management
Web UI based management, SNMP v1/v2, Serial Console
Qos, traffic classification QoS, Cos, bandwidth control for Ingress and Egress,
broadcast storm control, Diffserv
IEEE802.1q VLAN, port-based VLAN support
IGMP snooping v1/v2, IGMP filtering / throttling, IGMP query up to 256 group
Supports RMON, MIB II, port mirroring, event syslog, DNS, NTP/SNTP, SSH/SSL,
TFTP.
Advanced PoE Ports Management (auto ping check)
Auto powered device (PD) detection
Auto reset (cycle power to unresponsive PD)
