Antaira Technologies
IMP-C100-XX Series
Compact 10/100Tx to 100Fx Industrial Media Converter
with SC/ST Connector and PoE Injector
Quick Installation Guide
Version 1.1
(Feb 2020)
Tel: 1-844-268-2472
Fax: 1-714-671-9944
www.antaira.com
Package Check List
The package contains the following items:
1
– Quick installation guide
1
– IMP-C100-XX(-T)
1
– Wall mounting bracket set with screws
1
– DC cable –18 AWG & DC jack 5.5 x 2.1mm
1
– RJ45 dust cover set
Front Panel Layout
Top Panel View
IMP-C100-XX series top panel is equipped with one 6-pin
removal terminal block connector for dual DC power inputs
(48~55VDC).
Product Overview
System Interface/Performance
All RJ45 ports support the auto MDI/MDI-X function
Embedded 1*10/100Tx (PSE: 30W/Port) Fast Ethernet and
1*100Fx SC/ST type connector with Multi/Single-mode
Store-and-forward switching architecture
Power Input & Connection
DC 48 to 55V redundant power, with a 6-pin removal
terminal block
It is recommended to use a UL listed industrial power supply
Operating Temperature
Standard operating temperature model: -10°C to 70°C
Extended operating temperature model: -40°C to 80°C
Case/Installation
IP30 protection
DIN-Rail and wall mount design
LED Indicators
LED
Color
Description
Power 1
Green
On
Power input 1 is active
Off
Power input 1 is inactive
Power 2
Green
On
Power input 2 is active
Off
Power input 2 is inactive
Fault
Red
On
Power input 1 or 2 is inactive or port link failed
Off
Power input 1 or 2 are both functional and port link is
correct
LAN Port
(Upper LED)
Green
On
Connected to network, 10/100Mbps
Flashing
Networking is active
Off
Not connected to network
LAN Port
(Lower LED)
Green
On
Connected to network, 100Mbps
Off
Connected to network, 10Mbps
100FX
Fiber Port
(LINK/ACT)
Green
On
Connected to network, 100Mbps
Flashing
Networking is active
Off
Not connected to network
PoE
Green
On
The port is supplying power to the powered-device
Off
No powered-device attached or power supplying
fails
DIP Switch
DIP
Switch
1
2
Fiber Port
Setting
Copper Port Settings
3
4
5
6
ON
LFP
Enable
Converter
Mode
Half-Duplex
Mode
Auto-negotiation
Disable
10Mbps
Half-Duplex
Mode
OFF
LNP
Disable
Switch
Mode
Full-Duplex
Mode
Auto-negotiation
Enable
100Mbps
Full-Duplex
Mode
Note: After any DIP switch changes have been made, it is
required to power cycle the unit for the changes to take effect
Quick Installation
Ethernet Ports
RJ45 Ports (Auto MDI/MDI-X)
All RJ45 ports are auto-sensing for 10Base-T or 100Base-TX
device connections. Please follow the wiring pin assignment
table below for Ethernet port installation.
Grounding Screw
6-Pin Removal Terminal Block (Power Input)
LAN Port
– 10/100Tx RJ45
LAN Port
– LED for Link/Activity Status
10/100Mbps
LAN Port
– LED for Speed Status
LED for Power 1, Power 2, and Fault
Grounding Screw
6-Pin Removal Terminal Block (Power Input)
Fiber Port
– 100Fx
Fiber Port
– LED for Link/Activity Status
DIP Switch
LED for PoE Status
