A-1
Appendix A.
Device and Point Types
Introduction
This appendix lists and explains the following:
•
Hardware Device Types. AUTOPULSE Z-28 hardware device types are listed with their
corresponding part numbers, allowing you to exactly match the equipment used with the
available device types.
•
Software Point Types. AUTOPULSE Z-28 point types are grouped into two general
categories:
•
Monitor point types are used with monitoring devices, such as smoke detectors, pull
stations, heat detectors, fire pump monitors, etc.
•
Control point types are used with signal (notification appliance) and relay devices.
•
Point Addresses and definitions. Each AUTOPULSE Z-28 point has a point address, such
as 1-1 (NAC card signal 1 address). A point address and an understanding of when the
point turns ON and OFF are necessary for referencing points in Custom Control equations.
In This Chapter
This chapter discusses the following topics:
Topic
See Page #
Device Types
A-2
Control Point Types
A-3
Monitor Point Types
A-9
24-Point I/O Types
A-17
Addresses for Hardware Points
A-18
Addresses for Pseudo Points
A-25
