SE
24
GB
ASSEMBLY OF THE FAN BLADE AND GRILLE
Fig. 2
Fit the fan blade on the shaft
Lock nut
Fig. 1
• Remove the lock nut from the motor shaft by turning it anti-clockwise.
• Place the rear grille against the front of the motor housing, with the handle facing upwards. The
guide pins on the motor housing should mate in the holes in the rear grille (fig. 1).
• Lock the grille in place, by refitting the lock nut and tighten by hand (fig. 1). Do not overtighten.
• Fit the fan blade on the motor shaft with the slot at the rear of the blade over the pin in the
motor shaft.
Fig. 3
Fig. 4
• Fold out the locking clips on the front grille (fig. 3).
• Place the front grille against the rear grille, so that the holes along the edges are aligned. Press
the grille clips in position over the edge of the grille. Insert the screw through the hole and screw
on the nut (fig. 4).
USE
IMPORTANT!
• Put the appliance in a suitable place as set out in the safety instructions.
• Route the power cord so that there is no risk of tripping over it.
• Do not mount the appliance on a wall or ceiling.
• Remove the cable tie and unwrap the cord before use.
