Anrtisu Cell Master MT8212B, Руководство пользователя, Страница: 228 / 294

Multipath Power (available only with OTA - Option 33)
The amount of power in the dominant signal which is being spread in time due to multipath
echoes. This should be <0.4 dB to make good measurements.
D Sync (available only with OTA - Option 33)
Sync Walsh code power relative to the pilot power.
D Page (available only with OTA - Option 33)
Page Walsh code power relative to the pilot power.
D QPage (available only with OTA - Option 33)
Quick Page Walsh code 80 power relative to the pilot power.
CDMA RF Measurements
To make CDMA RF measurements, connect the Cell Master to the base station following
the setup instructions.
Step 1.
On the Cell Master, press the MODE key, use the Up/Down arrow key to select
the
CDMA
mode and press ENTER .
Step 2. Select the
Signal Standard
soft key and press the
Select Standard
soft key. Use
the soft keys or the Up/Down arrow key to highlight the appropriate standard,
such as
CDMA US PCS
, and press ENTER .
Step 3. Press the
Select Channel
soft key and use the Up/Down arrow key or the nu-
meric keypad to enter the appropriate channel, such as
50
, and press ENTER .
Step 4. Press the MEAS/DISP key and select the
RF Meas
soft key to display the RF
Measurements screen.
13-6
Chapter 13 CDMA Measurement
Figure 13-1. CDMA RF Measurements Screen