Anritsu 3659, Руководство пользователя, Страница: 41 / 160

Using the 2300-580-R Software with VectorStar ME7838D 2-11 Matched Thru Tests
3659 0.8 mm Cal/Ver Kit & 2300-580-R PVS UG PN: 10410-00327 Rev. D 2-29
2-11 Matched Thru Tests
If the
Run All Tests
button on the
Application Interface - Main Menu
tab was selected, the
Matched Thru
tests
(immediately below) are executed followed by the
Mismatched Thru
tests described in Section 2-12 “Mismatched
Thru Tests” on page 2-31 below.
If the
Matched Thru
test button was selected, only the steps in this section are executed. When this test is
complete, the program returns to the main menu described Section 2-9 “Application Interface – Main Menu
Tab” on page 2-24 above.
Procedure
1. The
Enter Serial Number Match Thru
dialog box appears.
2. Ensure that the correct device is connected.
• The
Matched Thru
verification standard is the device with one scribe line.
• The
Mismatched Thru
verification standard is the device with two scribe lines.
3. Enter the serial number of the Matched Thru.
4. When ready to proceed, click
OK
. The
Connect Mismatched Thru Male Connector
dialog box appears.
5. Connect the Matched Thru male connector to VNA Port 1 with the label facing up.
Note
The verification devices must be connected to the 0.8 mm Connector Coupler Ports and not to the
VNA Ports . Use the torque wrench supplied with the verification kit when tightening the device
connections.
Figure 2-39. Enter Serial Number Thru Dialog
Note
The verification standards must be connected to the 0.8 mm Coupler Ports and not to the VNA
ports .
Figure 2-40. Connect the Mismatched Thru Dialog